Ceratec Slaty Almond Matte Porcelain Tile 12" x 12"

Natural stone needs sealing and every batch looks different. Slaty Almond gives you a stone look in porcelain that stays consistent.

In simple terms: Slaty Almond is a 12x12 stone look porcelain tile for floors and walls, indoors and out.

It is the matte finish in Almond from the Ceratec Slaty range.

The actual size is 11.8" x 11.8" (300 x 300 mm). It is 9.8 mm thick. The body is coloured to match the surface, so a chip shows less than it would on a white-body tile. The spec sheet lists PEI V surface abrasion rating, a wet DCOF slip reading above 0.42, an R10 slip rating and water absorption below 0.5%. It is rated for heavy commercial traffic. It is frost resistant. Shade variation is V4, dramatic. It is made in Italy. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits kitchen floors, bathroom floors, hallways, basements, shower and bathroom walls, covered porches and patios and commercial floors such as stores and offices. Pick it over real stone when you want the look with no sealing.

Each box holds 12 pieces and covers 11.6 sq ft, so a 40 sq ft bathroom floor takes 4 boxes, and that still leaves about 10% extra for cuts and spares. For every 100 sq ft, plan on 10 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside. At V4 the shade moves a lot from piece to piece, so we blend from several boxes as we lay it.

In this size, Slaty also comes in Multicolor and Ochre. Almond also comes in 12" x 24", 3" x 6" and 2" x 2". For edges, Ceratec recommends a 1/2" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec Slaty Almond in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).