Ceratec Chicago Loop Matte Porcelain Tile 12" x 24"

Natural stone needs sealing and every batch looks different. Chicago Loop gives you a stone look in porcelain that stays consistent.

In simple terms: Chicago Loop is a 12x24 stone look porcelain tile for floors and walls, indoors and out.

It is the matte finish in Loop from the Ceratec Chicago range.

The actual size is 11.7" x 23.5" (297 x 597 mm). It is 9.5 mm thick. The body is coloured to match the surface, so a chip shows less than it would on a white-body tile. The spec sheet lists PEI V surface abrasion rating, a wet DCOF slip reading above 0.42, an R10 slip rating and water absorption below 0.5%. It is rated for heavy commercial traffic. It is frost resistant. Shade variation is V2, slight. It is made in Portugal. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits open-plan floors, living areas, basements, shower and bathroom walls, covered porches and patios and commercial floors such as stores and offices. Pick it over real stone when you want the look with no sealing.

Each box holds 5 pieces and covers 9.55 sq ft, so a 150 sq ft kitchen floor takes 16 boxes, or 18 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 12 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

In this size, Chicago also comes in Lake, Night and Skydeck. Loop also comes in 24" x 24". For edges, Ceratec recommends a 1/2" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec Chicago Loop in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).