Olympia Tile Digitalart Night Anthracite Matte Porcelain Tile 12" x 24"

A soft, woven look usually means fabric or wallpaper, which a kitchen or bathroom will ruin. Digitalart Night Anthracite puts that texture on porcelain.

In simple terms: Digitalart Night Anthracite is a 12x24 fabric look porcelain tile for floors and walls, indoors and out.

It is the matte finish in Night Anthracite from the Olympia Tile Digitalart range. It has a fabric and patterned look. The actual size is 11.81" x 23.62", or 30 x 60 cm.

It is 10 mm thick. The edges are rectified, so it can be set with a tight grout joint. The body is coloured to match the surface, so a chip shows less than it would on a white-body tile. It is rated for high commercial traffic. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself does not need sealing.

It suits open-plan floors, living areas, basements, shower and bathroom walls, covered porches and patios and busy commercial floors such as stores and offices. Pick it over a smaller tile when you want fewer grout lines; pick smaller if the floor is out of level.

Each box holds 7 pieces and covers 13.57 sq ft, so a 150 sq ft kitchen floor takes 12 boxes, or 13 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 9 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

In this size, Digitalart also comes in Denim, Ecru Light Beige, Grey and White.

Our own crews install it, so the people who measure the job are the people who answer for it. See Olympia Tile Digitalart Night Anthracite in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).