Ceratec Westside White Matte Porcelain Tile 12" x 24"

Hardwood does not belong in a wet bathroom or a damp basement. Westside White gives you the wood look in porcelain that can go there.

In simple terms: Westside White is a 12x24 wood look porcelain tile for floors and walls, indoors and out.

It is the matte finish in White from the Ceratec Westside range.

The actual size is 11.8" x 23.6" (300 x 600 mm). It is 8.5 mm thick. The spec sheet lists PEI IV surface abrasion rating, a wet DCOF slip reading above 0.42 and water absorption below 0.5%. It is rated for commercial traffic. It is frost resistant. Shade variation is V2, slight. It is designed by Ceratec in Canada and made in Turkey. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits basements, kitchens and bathrooms where hardwood would not stand up to water, open-plan floors, living areas, shower and bathroom walls, covered porches and patios and commercial floors such as stores and offices. Pick it over hardwood or laminate anywhere the floor can get wet.

Each box holds 9 pieces and covers 17.4 sq ft, so a 150 sq ft kitchen floor takes 9 boxes, or 10 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 7 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

In this size, Westside also comes in Grey and Silver. White also comes in 2" x 2" and 12" x 12". For edges, Ceratec recommends a 3/8" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec Westside White in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).