Ceratec New Stone Visone Matte Porcelain Tile 24" x 24"

Natural stone needs sealing and every batch looks different. New Stone Visone gives you a stone look in porcelain that stays consistent.

In simple terms: New Stone Visone is a 24x24 stone look porcelain tile for floors and walls, indoors and out.

It is the matte finish in Visone from the Ceratec New Stone range.

The actual size is 23.6" x 23.6" (600 x 600 mm). It is 8 mm thick. The edges are rectified, so it can be set with a tight grout joint. The spec sheet lists PEI IV surface abrasion rating, a wet DCOF slip reading of 0.50, an R10 slip rating and water absorption of 0.3%. It is rated for commercial traffic. It is frost resistant. Shade variation is V3, moderate. It is made in Italy. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits open-plan floors, living areas, basements, shower and bathroom walls, covered porches and patios and commercial floors such as stores and offices. Pick it over real stone when you want the look with no sealing.

Each box holds 5 pieces and covers 19.34 sq ft, so a 150 sq ft kitchen floor takes 8 boxes, or 9 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 6 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

In this size, New Stone also comes in Daino and Lepre. For edges, Ceratec recommends a 1/2" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec New Stone Visone in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).