Ceratec Lux Bronze Matte Porcelain Tile 24" x 24"

Large tile means fewer grout lines to scrub, and a room reads bigger with them. Lux Bronze gives you that in 24" x 24".

In simple terms: Lux Bronze is a 24x24 porcelain tile for floors and walls, indoors and out.

It is the matte finish in Bronze from the Ceratec Lux range.

The actual size is 23.6" x 23.6" (600 x 600 mm). It is 7 mm thick. The spec sheet lists PEI III surface abrasion rating, a wet DCOF slip reading above 0.42 and water absorption below 0.5%. It is rated for light commercial traffic. It is frost resistant. Shade variation is V3, moderate. It is designed by Ceratec in Canada and made in Turkey. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits open-plan floors, living areas, basements, shower and bathroom walls and covered porches and patios. Pick it over a smaller tile when you want fewer grout lines; pick smaller if the floor is out of level.

Each box holds 4 pieces and covers 15.47 sq ft, so a 150 sq ft kitchen floor takes 10 boxes, or 11 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 8 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside. It is rated for light commercial traffic, so keep it out of busy commercial floors.

In this size, Lux also comes in Anthracite, Bianco and Grigio. For edges, Ceratec recommends a 3/8" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec Lux Bronze in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).