Ceratec Elisir Royal Castano Matte Porcelain Chevron Tile 3" x 18"

Hardwood does not belong in a wet bathroom or a damp basement. Elisir Royal Castano Chevron gives you the wood look in porcelain that can go there.

In simple terms: Elisir Royal Castano Chevron is a 3x18 wood look porcelain tile for floors and walls, indoors and out.

It is the matte finish in Castano from the Ceratec Elisir Royal range. The pattern or piece type is chevron.

The actual size is 2.9" x 17.7" (75 x 450 mm). It is 9 mm thick. The body is coloured to match the surface, so a chip shows less than it would on a white-body tile. The spec sheet lists a wet DCOF slip reading of 0.69, an R9 slip rating and water absorption of 0.1%. It is rated for commercial traffic. It is frost resistant. Shade variation is V3, moderate. It is made in Italy. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits basements, kitchens and bathrooms where hardwood would not stand up to water, kitchen floors, bathroom floors, hallways, shower and bathroom walls, covered porches and patios and commercial floors such as stores and offices. Pick it over hardwood or laminate anywhere the floor can get wet.

Each box holds 26 pieces and covers 9.27 sq ft, so a 150 sq ft kitchen floor takes 17 boxes, or 18 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 12 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

In this size, Elisir Royal also comes in Beige and Dorato. Castano also comes in 8" x 48". For edges, Ceratec recommends a 1/2" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec Elisir Royal Castano Chevron in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).