Ceratec Alabastrino Marfil Satin Porcelain Tile 24" x 24"

Real marble etches, stains and needs sealing. Alabastrino Marfil gives you the marble look in porcelain that does not.

In simple terms: Alabastrino Marfil is a 24x24 marble look porcelain tile for floors and walls, indoors and out.

It is the satin finish in Marfil from the Ceratec Alabastrino range.

The actual size is 23.4" x 23.4" (590 x 590 mm). It is 9 mm thick. The edges are rectified, so it can be set with a tight grout joint. The spec sheet lists PEI IV surface abrasion rating and water absorption below 0.5%. It is rated for commercial traffic. It is frost resistant. Shade variation is V2, slight. It is made in Spain. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits open-plan floors, living areas, basements, shower and bathroom walls and commercial floors such as stores and offices. Pick it over real marble when you want the veining without sealing or etching.

Each box holds 4 pieces and covers 15.21 sq ft, so a 150 sq ft kitchen floor takes 10 boxes, or 11 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 8 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

Marfil also comes in 24" x 48". For edges, Ceratec recommends a 1/2" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec Alabastrino Marfil in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).