Ceratec Taj Mahal Greige Matte Porcelain Tile 24" x 24"

Real marble etches, stains and needs sealing. Taj Mahal Greige gives you the marble look in porcelain that does not.

In simple terms: Taj Mahal Greige is a 24x24 marble look porcelain tile for floors and walls, indoors and out.

It is the matte finish in Greige from the Ceratec Taj Mahal range.

The actual size is 23.6" x 23.6" (600 x 600 mm). It is 9.5 mm thick. The edges are rectified, so it can be set with a tight grout joint. The spec sheet lists PEI IV surface abrasion rating, a wet DCOF slip reading of 0.65, an R10 slip rating and water absorption of 0.04%. It is rated for commercial traffic. It is frost resistant. Shade variation is V2, slight. It is designed by Ceratec in Canada and made in China. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits open-plan floors, living areas, basements, shower and bathroom walls, covered porches and patios and commercial floors such as stores and offices. Pick it over real marble when you want the veining without sealing or etching.

Each box holds 4 pieces and covers 15.47 sq ft, so a 150 sq ft kitchen floor takes 10 boxes, or 11 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 8 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

In this size, Taj Mahal also comes in Argento. Greige also comes in 12" x 24" and 24" x 48". For edges, Ceratec recommends a 1/2" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec Taj Mahal Greige in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).