Ceratec Metallica Steel White Matte Porcelain Tile 24" x 48"

Metal sheeting dents and scratches on a wall or floor. Metallica Steel White gives you a metallic look in porcelain.

In simple terms: Metallica Steel White is a 24x48 metal look porcelain tile for floors and walls, indoors and out.

It is the matte finish in Steel White from the Ceratec Metallica range.

The actual size is 23.6" x 47.2" (600 x 1200 mm). It is 9.5 mm thick. The edges are rectified, so it can be set with a tight grout joint. The body is coloured to match the surface, so a chip shows less than it would on a white-body tile. The spec sheet lists PEI V surface abrasion rating, a wet DCOF slip reading above 0.42, an R10 slip rating and water absorption below 0.5%. It is rated for heavy commercial traffic. It is frost resistant. Shade variation is V3, moderate. It is made in Italy. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits open-plan floors, living areas, basements, shower and bathroom walls, covered porches and patios and commercial floors such as stores and offices. Pick it over a smaller tile when you want fewer grout lines; pick smaller if the floor is out of level.

Each box holds 2 pieces and covers 15.47 sq ft, so a 150 sq ft kitchen floor takes 10 boxes, or 11 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 8 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

In this size, Metallica also comes in Steel and Dark. Steel White also comes in 12" x 24". For edges, Ceratec recommends a 1/2" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec Metallica Steel White in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).