Ceratec District Crema Matte Porcelain Tile 12" x 24"

Large tile means fewer grout lines to scrub, and a room reads bigger with them. District Crema gives you that in 12" x 24".

In simple terms: District Crema is a 12x24 porcelain tile for floors and walls, indoors and out.

It is the matte finish in Crema from the Ceratec District range.

The actual size is 11.8" x 23.6" (300 x 600 mm). It is 7.5 mm thick. The spec sheet lists PEI IV surface abrasion rating, a wet DCOF slip reading above 0.42, an R9 slip rating and water absorption below 0.5%. It is rated for commercial traffic. It is frost resistant. Shade variation is V2, slight. It is designed by Ceratec in Canada and made in Turkey. Porcelain is fired dense, so it handles water, spills and daily foot traffic and the tile itself never needs sealing.

It suits open-plan floors, living areas, basements, shower and bathroom walls, covered porches and patios and commercial floors such as stores and offices. Pick it over a smaller tile when you want fewer grout lines; pick smaller if the floor is out of level.

Each box holds 9 pieces and covers 17.4 sq ft, so a 150 sq ft kitchen floor takes 9 boxes, or 10 boxes with about 10% extra for cuts and spares. For every 100 sq ft, plan on 7 boxes with the 10% extra included.

It is listed for outdoor use, but an outdoor floor also needs the right base and slope, so ask us before planning it outside.

In this size, District also comes in Grigio and Taupe. For edges, Ceratec recommends a 3/8" trim profile.

Our own crews install it, so the people who measure the job are the people who answer for it. See Ceratec District Crema in person at our Mississauga showroom (700 Dundas St E, Unit 3-4, 905-277-2227) or our Barrie showroom (112 Saunders Rd, Units 1-4, 705-726-2272).